PDF

REVIEW DRAFT—CISCO CONFIDENTIAL
EU Directive 1999/5/EC: Compliance Information
for the Cisco Aironet 1430 Series
Wireless Bridges
January, 2009
This document contains compliance information for the Cisco Aironet 1430 series wireless bridges that
is relevant to the European Union and other countries that have implemented the EU Directive
1999/5/EC.
Contents
This document contains these sections:
Scope, page 1
Declaration of Conformity with Regard to the EU Directive 1999/5/EC (R&TTE Directive), page 2
CE Marking, page 4
National Restrictions, page 4
Antennas, page 4
Operating Frequency, page 5
Configuring Radio Transmit Power, page 6
Related Documentation, page 7
Obtaining Documentation and Submitting a Service Request, page 7
Scope
The information in this document applies to the Cisco Aironet 1430 series wireless bridge products,
which currently include the AIR-BR1430UN0-E-K9, AIR-BR1430UN1-E-K9, AIR-BR1430UI0-E-K9,
and the AIR-BR1430UI1-E-K9.
Americas Headquarters:
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
Declaration of Conformity with Regard to the EU Directive 1999/5/EC (R&TTE Directive)
REVIEW DRAFT—CISCO CONFIDENTIAL
Declaration of Conformity with Regard to the EU Directive
1999/5/EC (R&TTE Directive)
This declaration is only valid for configurations (combinations of software, firmware and hardware)
supported or provided by Cisco Systems for use within the EU. The use of software or firmware not
supported or provided by Cisco Systems may result in the equipment no longer being compliant with the
regulatory requirements.
EU Directive 1999/5/EC: Compliance Information for the Cisco Aironet 1430 Series Wireless Bridges
2
78-18982-01
Declaration of Conformity with Regard to the EU Directive 1999/5/EC (R&TTE Directive)
REVIEW DRAFT—CISCO CONFIDENTIAL
Note
The full declaration of conformity for this product can be found in the Getting Started Guide: Cisco
Aironet 1430 Series Wireless Bridge, which is available on Cisco.com. See the “Obtaining
Documentation and Submitting a Service Request” section on page 7 for instructions for downloading
these documents.
The following standards were applied during the assessment of the product against the requirements of
the Directive 1999/5/EC:
•
Radio: EN 301.893
•
EMC: EN 301 489-1 and EN 301 489-17
•
Safety: EN 60950-1, EN 60950-22, and EN 50385
EU Directive 1999/5/EC: Compliance Information for the Cisco Aironet 1430 Series Wireless Bridges
78-18982-01
3
Declaration of Conformity with Regard to the EU Directive 1999/5/EC (R&TTE Directive)
REVIEW DRAFT—CISCO CONFIDENTIAL
CE Marking
For the Cisco Aironet AIR-BR1430UN0-E-K9, AIR-BR1430UN1-E-K9, AIR-BR1430UI0-E-K9, and
the AIR-BR1430UI1-E-K9, the following CE mark and Class-2 identifier are affixed to the equipment
and its packaging:
National Restrictions
The 5 470 to 5725 MHz is available in all EU countries as well as in most other European Countries.
The requirements for any country may evolve. Cisco recommends that you check with the local
authorities for the latest status of their national regulations for 5-GHz wireless LANs.
Italy
This product meets the National Radio Interface and the requirements specified in the National
Frequency Allocation Table for Italy. Unless this wireless LAN product is operating within the
boundaries of the owner’s property, its use requires a “general authorization.” Please check
http://www.sviluppoeconomico.gov.it/ for more details.
Questo prodotto è conforme alla specifiche di Interfaccia Radio Nazionali e rispetta il Piano Nazionale
di ripartizione delle frequenze in Italia. Se non viene installato all’interno del proprio fondo, l’utilizzo
di prodotti Wireless LAN richiede una “Autorizzazione Generale”. Consultare
http://www.sviluppoeconomico.gov.it/ per maggiori dettagli.
Note
Although Norway, Switzerland and Liechtenstein are not EU member states, the EU Directive
1999/5/EC has also been implemented in those countries.
Note
The regulatory limits for maximum output power are specified in EIRP. The EIRP level of a device can
be calculated by adding the gain of the antenna used (specified in dBi) to the output power available at
the connector (specified in dBm).
Antennas
This section contains regulatory information for the antennas available for the Cisco Aironet 1430 series
wireless bridges.
Products with Integral Antennas:
•
AIR-BR1430UI0-E-K9
•
AIR-BR1430UI1-E-K9
EU Directive 1999/5/EC: Compliance Information for the Cisco Aironet 1430 Series Wireless Bridges
4
78-18982-01
Declaration of Conformity with Regard to the EU Directive 1999/5/EC (R&TTE Directive)
REVIEW DRAFT—CISCO CONFIDENTIAL
The 5-GHz wireless bridges—Cisco Aironet AIR-BR1430UI0-E-K9 and AIR-BR1430UI1-E-K9—have
integrated antennas which cannot be removed or which are not user accessible. Nevertheless, as
regulatory limits are not the same throughout the EU, users may need to adjust the conducted power
setting for the radio to meet the EIRP limits applicable in their country or region.
Table 1
Maximum Conducted Power Settings—Integral Antennas
Cisco Part Number
AIR-BR1430UI0-E-K9
AIR-BR1430UI1-E-K9
Antenna
Gain (dBi)
Regulatory Limit
(eirp) (dBm/mW)
Maximum
Conducted Power
Setting (dBm)1
Antenna
Description
20
30/1000
10
Integral antenna
1. Available conducted power settings for this product are 4, 7, and 10 dBm.
Products with Dedicated (External) Antennas:
•
AIR-BR1430UN0-E-K9
•
AIR-BR1430UN1-E-K9
The Cisco Aironet AIR-BR1430UN0-E-K9 and the AIR-BR1430UN1-E-K9 wireless bridges are
equipped with N-type antenna connectors to allow the use of dedicated (external) antennas available
from Cisco.
Table 2 list the antennas that can be used with these products. All antennas where assessed together with
the equipment against the requirements of the R&TTE directive. The table also lists the maximum
conducted power setting for each of the antennas.
Depending on the country, a different regulatory limit might be applicable. It is therefore the
responsibility of the end user to select a power level that, together with the antenna, results in an eirp
(radiated power) level that is below the applicable limit.
Table 2
Maximum Conducted Power Settings—External Antennas
Antenna Part Number
Antenna
Gain (dBi)
Regulatory
Limit (eirp)
(dBm/mW)
Maximum
Conducted Power
Setting (dBm)1
Antenna Name
AIR-ANT5180V-N
8
30/1000
16
Omni-directional antenna
AIR-ANT58G10SSA-N
9.5
16
Sector antenna
AIR-ANT5114P-N
14
16
Patch antenna
AIR-ANT5117S-N
17
13
90-degree sector antenna
1. Available conducted power settings for this product are 4, 7, 10, 13, and 16 dBm.
Operating Frequency
This devices operates within the 5470-MHz to 5725-MHz band.
EU Directive 1999/5/EC: Compliance Information for the Cisco Aironet 1430 Series Wireless Bridges
78-18982-01
5
Declaration of Conformity with Regard to the EU Directive 1999/5/EC (R&TTE Directive)
REVIEW DRAFT—CISCO CONFIDENTIAL
Configuring Radio Transmit Power
To change the radio transmit power of the bridge, follow these steps:
Step 1
Open a web browser window and enter the IP address of the device you want to configure.
Step 2
Enter your authentication information and click OK.
Note
Figure 1
Administrator privileges may be required in order to change these settings.
Step 3
From the bridge home page, click the SETTINGS tab.
Step 4
From the NETWORK INTERFACES menu on the left side of the window, click Radio1-802.11N5GHz.
Put Screen Capture of European GUI Here
EU Directive 1999/5/EC: Compliance Information for the Cisco Aironet 1430 Series Wireless Bridges
6
78-18982-01
Related Documentation
REVIEW DRAFT—CISCO CONFIDENTIAL
Step 5
From the Network Interfaces: Radio1-802.11N5GHz Settings page, select one of the radio buttons in the
Transmitter Power (Configured Power) section. The available options are 4, 7, 10, 13, and 16 dBm. The
default transmit power is 16 dBm.
Step 6
Click Apply to save your changes.
John - See Fred about getting a screen capture of a European bridge GUI that shows this setting.
Make sure the Transmitter Power options match the text! Also, verify that “Apply” is correct to save
changes.
Related Documentation
These documents provide information about the Cisco Aironet 1430 series wireless bridges. They are
available through the following Cisco.com web page:
http://www.cisco.com/en/US/products/hw/wireless/ps5279/tsd_products_support_series_home.html
Note
•
Getting Started Guide: Cisco Aironet 1430 Series Wireless Bridge—a basic overview of the setup
and installation instructions for the Aironet 1430 series wireless bridges, as well as the complete
translated text of all required declarations of conformity.
•
Cisco IOS Software Configuration Guide for the Cisco Aironet 1400 Series Wireless Bridge
(12.3(8)JA)—detailed configuration information for the Aironet 1400 series wireless bridges.
•
Cisco Aironet 1430 Series Wireless Bridge Mounting Instructions—installation and mounting
instructions for the Aironet 1430 series wireless bridge.
•
Translated Safety Warnings for Cisco Aironet 1430 Series Wireless Bridges—safety warnings and
regulatory information for the Aironet 1430 series wireless bridge.
If you still have questions regarding the compliance of these products or you cannot find the compliance
information you are looking for, please send an e-mail request to Cisco at complianceinfo@cisco.com.
Obtaining Documentation and Submitting a Service Request
For information on obtaining documentation, submitting a service request, and gathering additional
information, see the monthly What’s New in Cisco Product Documentation, which also lists all new and
revised Cisco technical documentation, at:
http://www.cisco.com/en/US/docs/general/whatsnew/whatsnew.html
Subscribe to the What’s New in Cisco Product Documentation as a Really Simple Syndication (RSS) feed
and set content to be delivered directly to your desktop using a reader application. The RSS feeds are a free
service and Cisco currently supports RSS Version 2.0.
EU Directive 1999/5/EC: Compliance Information for the Cisco Aironet 1430 Series Wireless Bridges
78-18982-01
7
Obtaining Documentation and Submitting a Service Request
REVIEW DRAFT—CISCO CONFIDENTIAL
Cisco and the Cisco Logo are trademarks of Cisco Systems, Inc. and/or its affiliates in the U.S. and other countries. A listing of Cisco's trademarks
can be found at www.cisco.com/go/trademarks. Third party trademarks mentioned are the property of their respective owners. The use of the word
partner does not imply a partnership relationship between Cisco and any other company. (1005R)
EU Directive 1999/5/EC: Compliance Information for the Cisco Aironet 1430 Series Wireless Bridges
8
78-18982-01

Download Report