Fire DATA SHEET Analogue Interface Zone Monitor Unit CZMU352 / MIU871 / FXN512 An extensive range of interfaces are available for the Cooper, Menvier and JSB range of analogue panels providing solutions for most design requirements. Benefits and Features > Monitors a zone of compatible conventional detectors These zone monitor units, connect zones of suitable conventional detectors or loop powered beam detectors. > Only takes a single address > Simple to install > Input monitored for open and short circuits > Active end of line monitoring Technical Specifications Model CZMU352 / MIU871 / FXN512 Description Zone monitor unit Standards EN54: Pts 17 & 18; 2005 EMC CE marked Operating voltage 18 to 30 V dc Quiescent current 2.8 mA Current with 20 detectors 3.4 mA Total alarm current 8 mA Addressing mode auto addressed Detector zone loading 20 detectors (max) Callpoint load unlimited Cable size (Min-Max) 0.5 to 2.5mm² Recommended cable types (UK) Draka - FIRETUF, Pirelli - FP200, MICC Environmental IP40. -10°C to +60°C. Humidity 0 to 95% non condensing Physical Construction ABS Dimensions (W x H x D) 147mm x 88mm x 57mm Compatibility Analogue addressable fire systems Note. 1. For use with only Cooper / JSB conventional detector bases with schottky diode configuration may be used (active end of line monitoring - EOLM-1). 2. For use with only Cooper / JSB callpoints. Wiring Diagram EOLM-1 12K - Out + - In + Analogue addressable loop E - + Out E - Loop + - Out + - In + - E In + Callpoint zone E - Notes: 1. Cable earth screen must be connected to its adjacent earth terminal. 2. The end of line resistor must always be fitted, even if the spur is not used. 3. Maximum spur length - see BS5839 Pt:1 2002 for zone coverage. 4. There is no maximum number of conventional callpoints allowed per zone output. 5. This unit can only be used with respective Cooper, Menvier and JSB Fire Systems, sensor base and compatible sensors. + Detector zone Callpoints can be connected with detectors on detector zone if preferred Installation > Zone monitor unit is fixed to a deep double gang back box (supplied) > All connections are via heavy duty terminals > Cable entry can be top, bottom, side or rear > Can be surface or semi recessed mounted > Maximum 20 detectors plus and unlimited number of callpoints can be connected Product Codes Zone monitor unit CZMU352 / MIU871 / FXN512 Cooper Lighting and Safety Wheatley Hall Road, Doncaster, South Yorkshire DN2 4NB www.cooperfire.com Sales T: +44 (0)1302 303 999 F: +44 (0)1302 303 333 E: sales@cooperfire.com DS0005a Technical T: +44 (0)1302 303 350 F: +44 (0)1302 303 332 E: techsupport@cooperfire.com Export T: +44 (0)1302 303 344 F: +44 (0)1302 303 345 E: export@cooperfire.com